Images for FluxBB

[kbd512]

Test

LC-Lot-9827-1.jpg (230.44 KiB) Viewed 69 times

[tahanson43206]

These images show the status of the extendedModel after a short run of 9 hours from 1 second to 1.25 seconds

Engine Pressure

20251020EnginePressure.png (16.99 KiB) Viewed 2085 times

Engine Temperature

20251020EngineTemperature.png (40.35 KiB) Viewed 2085 times

Engine Velocity

20251020EnginePressure.png (16.99 KiB) Viewed 2085 times

Intake Pressure

20251020EnginePressure.png (16.99 KiB) Viewed 2085 times

Intake Temperture:

20251020EngineTemperature.png (40.35 KiB) Viewed 2085 times

Intake Velocity

20251020EngineVelocity.png (47.7 KiB) Viewed 2085 times

[tahanson43206]

This image was contributed by GW Johnson

equations.jpg (88.03 KiB) Viewed 2205 times

[tahanson43206]

These images are from ParaView rendering of the status of extendedMerlin OpenFOAM model at 0.1 seconds into the first run with heaters turned on.

the heaters are activated to deliver 40 MW over a distance of 240 meters.

The model is designed to feed hydrogen at 300 Kelvin at a rate of 2 kg/s. the rate of flow ramps up slowly

20251017HeatForDotOneNozzleU.png (49.66 KiB) Viewed 2213 times

20251017HeatForDotOneNozzleT.png (22.87 KiB) Viewed 2213 times

20251017HeatForDotOneNozzlep.png (23.61 KiB) Viewed 2213 times

20251017HeatForDotOneIntakeU.png (11.68 KiB) Viewed 2213 times

20251017HeatForDotOneIntakeT.png (15.03 KiB) Viewed 2213 times

20251017HeatForDotOneIntakep.png (8.66 KiB) Viewed 2213 times

[tahanson43206]

This image by GW Johnson shows basics of orbit change at the Moon

orbit plane changes.png (86.91 KiB) Viewed 2996 times

[tahanson43206]

This run featured:

1) hydrogen filled model at 1 bar and 300 Kelvin at start
2) hydrogen input via ram to 2 kg/s at 2 seconds and run time of 3 seconds
3) outlet fixed at 1 bar so hydrogen above 1 bar escaped by below swirled in the engine compartment

The images here are taken about half way through the run... hydrogen is flowing through the nozzle

20251012MidRunVelocityDisplay.png (105.16 KiB) Viewed 5259 times

20251012MidRunTemperatureDisplay.png (81.43 KiB) Viewed 5259 times

20251012MidRunPressureDisplay.png (42.63 KiB) Viewed 5259 times

[tahanson43206]

Velocity display of hydrogen passing through nozzle from heat pipe.

20251010HydrogenPlumeExitNozzle.png (23.5 KiB) Viewed 5718 times

[tahanson43206]

Velocity

20251009RunTo2secondsOKVelocity.png (77.52 KiB) Viewed 8769 times

[tahanson43206]

Temperature:

20251009RunTo2secondsOKTemperature.png (62.25 KiB) Viewed 8769 times

[tahanson43206]

This image shows the engine compartment at 2 seconds with hydrogen ramping to 2 kg/s at 300 K, and outlet opening to pressure above 1 bar

20251009RunTo2secondsOKPressure.png (39.44 KiB) Viewed 8769 times